Library: Can Extraction Separate Contaminants?

Can Extraction Separate Contaminants?

Supercritical CO₂ extraction is a selective separation method. By adjusting pressure and temperature, target compounds pass into the extract while unwanted substances stay behind. The same selectivity applies to separating contaminants. Heavy metals do not pass into the extract. Fat-soluble pesticides can be separated or excluded depending on conditions.

Why Is CO₂ Selective?

Supercritical CO₂ (a fluid above its critical point) is a non-polar solvent. Its solvent power depends on density. Density depends on pressure and temperature. At low pressure (80 to 100 bar), only small and volatile molecules dissolve. As pressure increases, larger and more polar compounds also extract.

In commercial extraction, this tunability allows contaminants to stay excluded if the process operates within the solubility window of the target compound. For example, at low pressure, heavier pesticide molecules remain in the plant while the terpene fraction is extracted.

Heavy Metals Do Not Pass

Heavy metals (lead, cadmium, mercury, arsenic) have an ionic structure. They do not dissolve in non-polar solvents. Supercritical CO₂ does not extract heavy metals. Therefore, heavy metal concentration does not occur in plant extracts [1].

Heavy metal testing is performed on plant extracts. The raw material is the source. The value measured in the extract usually remains below the level present in the raw material.

Pesticides Can Be Separated

Organochlorine pesticides (DDT, heptachlor, endrin) dissolve in CO₂ at high pressure. The selectivity of CO₂ extraction can be used to separate these contaminants.

A study on dong quai (Angelica sinensis) optimized supercritical CO₂ extraction to separate 12 organochlorine pesticides from the plant. The result showed a high pesticide removal rate and low loss of active components [1]. This study shows that CO₂ can remove pesticides when extraction conditions are set correctly.

A method for pesticide analysis in onion extracted endrin and DDE with 80–103% recovery at 372 bar pressure [2]. This high pressure is used for analytical extraction. When lower pressures are used in commercial extraction, less pesticide is transferred.

Mycotoxins Depend on Raw Material

Aflatoxins are partially lipophilic. They can transfer into oil during oil extraction. The transfer rate depends on the method:

MethodAflatoxin Transfer Rate
Cold press55–57%
Pressing from roasted seeds37–47%
Hexane extraction18–20%

Transfer is highest in cold pressing and lowest in solvent extraction [3]. Mycotoxin transfer in CO₂ extraction is less studied, but the principle of selectivity applies here too.

Mycotoxin contamination starts in the raw material. The extract is clean when the raw material is clean.

PAH Depends on Drying Method

Polycyclic aromatic hydrocarbons (PAHs) dissolve in fats and move into the oil phase. The drying stage is the usual source of PAHs. Raw material dried over direct fire or smoke can carry PAHs [4].

Modern drying methods, such as low-temperature air drying and freeze drying, prevent PAH formation. Raw material selection matters here too.

What to Look for in the Document?

The technical data sheet (TDS) lists contaminant lines that show process safety.

Heavy metal. Limits for lead, cadmium, mercury, and arsenic. Low values are expected in CO₂ extracts.

Pesticide residue. Total limit or "not detected" statement for organochlorine and organophosphate pesticides. EU legislation (EC 396/2005) sets maximum residue limits by product group.

Mycotoxin. Limits for aflatoxin (B1, B2, G1, G2, and total). EU limits (EC 1881/2006) apply to food products.

PAH. Limits for benzo[a]pyrene and total PAH4. EU limits (EC 835/2011) apply to vegetable oils.

Solvent residue. Organic solvent is not used in CO₂ extraction. An ethanol residue line is present if a co-solvent (ethanol) was used.

References

  1. Zhao C, Hao G et al. Supercritical fluid extraction for the separation of organochlorine pesticides residue in Angelica sinensis. Biomedical Chromatography 2002. https://doi.org/10.1002/bmc.180
  2. Tolcha T, Gemechu T et al. High Density Supercritical Carbon Dioxide for the Extraction of Pesticide Residues in Onion. Molecules 2020. https://doi.org/10.3390/molecules25041012
  3. Var I, Uçkun O. Extraction Methods' Effects on Aflatoxin Concentration during Sunflower Oil Processing. European Journal of Agriculture and Food Sciences 2021. https://doi.org/10.24018/ejfood.2021.3.5.384
  4. Kariyawasam T, Doran G et al. Polycyclic aromatic hydrocarbon contamination in soils and sediments. Chemosphere 2022. https://doi.org/10.1016/j.chemosphere.2021.132981